Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
- Transmissions
+ Mechanical transmission (type 1)
+ Mechanical transmission (type 2)
- Automatic transmission (4 A/T)
+ The general description
+ Diagnostics of an automatic transmission
+ Safety measures at diagnostics of malfunctions
+ Visual survey
- Service out of a workshop
Liquid level
Liquid replacement
Hoses of a cooler of oil
Cable of a throttle of an automatic transmission
The manual selector
Gear change cable
The switch (gauge) of a range of transmission
The gauge of speed on an exit of an automatic transmission
The interruption switch on demand
Solenoidal valves
The switch of change of a food \norm
Tubes of a cooler of oil
+ System of blocking of brakes
+ System check
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
Gear change cable
Тип-1
Тип-2
Adjustment (for type-1)
|
|
- Before a nut tightening on the cable end switch the lever of a choice of transfer to position “N”.
- Also switch in position “N” the lever of a manual choice of transfer.
|
|
-
Be convinced that under the above described conditions the nut and cable connection has a backlash.
- If the cable of a choice of transfer has been shifted, move it in a direction of arrow C, against the stop, and then be convinced that the choice lever is in position “N”.
|
|
|
1 — the gauge (switch) of position of transmission
2 — a cable of a choice of transfer
3 — the lever of a manual choice of transfer
4 — the hinge of a cable of a choice of transfer |
- Turn nut A a hand while it will not concern the hinge of a cable of a manual choice of transfer.
- Then tighten nut B a wrench.
- After installation of a cable of a choice of transfer check up the following:
- Push the car when the lever of a choice of transfer is switched in position “P”. The car should not move.
- The car cannot go in position “N”.
- The car can go in position “D”, “2”, and “L”.
- The car can reverse in position “R”.
|
|
1 — the hinge of a cable of a choice of transfer
And — to level the cable hinge
In — to tighten a wrench |
|
|
Adjustment (for type-2)
|
|
- Loosen the a nut (1) levers of manual switching (from outside a choice cable).
- Switch the lever of a choice of transfer to position “N”.
|
|
- Level the central line (2) on a shaft of the manual valve (3) with a zero line “N” (4).
|
- Tighten a nut (1) levers of manual switching (from outside a cable of a choice of transfer) to the specified value of the moment of an inhaling. The inhaling moment: a nut of the lever of manual switching (a) — 19 Н•м (1.9 kg th, 14.0 pounds-foots).
- After installation of a cable of a choice of transfer check up the following:
- Push the car when the lever of a choice of transfer is switched in position “P”. The car should not move.
- The car cannot go in position “N”.
- The car can go in position “D”, “2”, and “L”.
- The car can reverse in position “R”.
|
|
|
|