Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation


Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
- Transmissions
   + Mechanical transmission (type 1)
   + Mechanical transmission (type 2)
   - Automatic transmission (4 A/T)
      + The general description
      + Diagnostics of an automatic transmission
      + Safety measures at diagnostics of malfunctions
      + Visual survey
      - Service out of a workshop
         Liquid level
         Liquid replacement
         Hoses of a cooler of oil
         Cable of a throttle of an automatic transmission
         The manual selector
         Gear change cable
         The switch (gauge) of a range of transmission
         The gauge of speed on an exit of an automatic transmission
         The interruption switch on demand
         Solenoidal valves
         The switch of change of a food \norm
         Tubes of a cooler of oil
      + System of blocking of brakes
      + System check
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment



Tubes of a cooler of oil

Removal

 PERFORMANCE ORDER

  1. Lift the car.
  2. Смойте a dirt from connections of tubes.
  3. Allow to the engine to cool down, ослабьте bolts of connecting oil tubes, having blocked a target oil branch pipe, and remove tubes of a cooler of oil from target oil branch pipes and hoses.

In order to avoid liquid leak remove face stoppers of target oil branch pipes and hoses right after their detachments.

Installation

 PERFORMANCE ORDER

  1. Use new linings for branch pipes and connect tubes of a cooler of oil to target oil branch pipes.
  2. Connect hoses to tubes and reliably fix clips.
  3. Having blocked a target oil branch pipe, tighten bolts of a branch pipe to the specified value of the moment of an inhaling. The inhaling moment (a): 35 Н•м (3.5 kg th, 25.5 pounds-foots). In case of use of linings with the basis from a copper alloy (bronze colour) (a): 25 Н•м (2.5 kg th, 18.0 pounds-foots). In case of use of the steel linings covered with rubber (black colour).
  4. Reliably tighten a tube bolt.
  5. Check up level of a liquid of an automatic transmission as it is described in section liquid Level. Add, if it is necessary.
  6. Having warmed up an automatic transmission, check up, whether there is no liquid leak.
1 — tubes of a cooler of oil
2 — linings of branch pipes
3 — a tube bolt