Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation

Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
- Engines
   + Mechanical part of engine G16
   - Mechanical part of engine J20
      + The general description
      - Routine maintenance
         Compression check
         Check of depression of the engine
         Check of pressure of oil
         Filtering element of the air filter
         The case throttle заслонок and an inlet collector
         Exhaust system collector
         Cover of a head of the cylinder
         Маслосборник and a grid of the oil pump
         The oil pump
         Cover of a chain of synchronisation
         The second chain of synchronisation and натяжитель chains
         The first chain of synchronisation and натяжитель chains
         Cam-shafts and regulators клапанного a backlash
         Valves and head of the block of the cylinder
         Pistons, piston rings, rods and cylinders
      + Assembly armature of the engine
      The special tool
      Necessary service materials
      Technical characteristics of the rotating moment of an inhaling
   + Engine cooling
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment

Cover of a head of the cylinder

PERFORMANCE ORDER

Disconnect a negative cable from the accumulator.
Disconnect муфты ignition coils.
Remove knots of the coil of ignition.
Separate a rope of an accelerator from a clip (only for vehicles with the left wheel).
Take out oil probe (1).

Disconnect a hose сапуна (2) and a hose of compulsory ventilation картера (3) from a cover of a head of the cylinder.

Uncover cylinder heads.

Installation

PERFORMANCE ORDER

Erase oil, old hermetic and a dust from condensed surfaces on a head of the cylinder and a cover.
Establish ring consolidations (3) and a lining of a cover of a head of the cylinder (2) on a cover of a head of the cylinder (1).

Do not forget to check up each of these details on presence of any damages or breakages before installation, and make replacement if damages are found out.

Establish a lateral sealant (4) on a cylinder head.

After clearing put hermetic "And" on area of a condensed surface of a head of the cylinder. "And": hermetic 99000-31250.

Establish a cover of a head of the cylinder on a cylinder head. Fasten nuts (3) while they will not be fastened with the specified rotating moment. The rotating moment of an inhaling: a nut of a cover of a head of the cylinder () — 11 Н•м (1.1 kg th, 8.0 pound on foot).

Use new sealing washers (1).

Establish coils of ignition and connect муфты ignition coils.
Insert oil probe (2).
Connect a hose сапуна and a hose of compulsory ventilation картера to a cover of a head of the cylinder.
Fix a rope of an accelerator a clip (only for vehicles with the left wheel).

home