Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
- Transfer
The general description
+ Diagnostics
- Service out of a workshop
Oil of a distributing box
The gear change lever
The switch of transfer of the all-wheel drive car
+ Oil epiploons of transfer
The gauge of speed
Back fixture of the engine
The transfer module
Removal
Installation
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
Removal
In an engine compartment
|
|
- Disconnect "minus" (–) a cable from the battery.
- Place a wooden plate (1) between the engine (2) or an inlet collector (3) both a partition between salon and a compartment of the engine (4) so that it served as a stopper when the engine, the transmission and transfer will hang when the back fixing part will be removed.
|
|
Do not forget to take advantage of a wooden plate not to admit possible contact between a partition of salon and a compartment of the engine and gauge SMR case (camshaft position) (at engine G16), gauge SMR (camshaft position) (at engine J20). |
For models with engines G16 and J20
|
|
t (thickness) — 45 mm (1.8 inches)
Н (height) — 200 mm (8 inches)
W (width) — 100 - 150 mm (4 6 inches) |
|
|
In salon
On the lift
|
|
- Merge transfer oil as it is described in the given Chapter, in Section Oil of a distributing box.
- Remove forward and back карданные shaft as it is described in Head Kardannye shaft, in Razdele Kardannyj a shaft.
- Disconnect an exhaust pipe №5 as it is described in the Head release System, in Section Components.
- Disconnect фитинг the gauge of speed.
|
|
- Put a jack under a transmission (1) and remove a back fixing part of the engine (2).
|
- Gradually lower a jack (1) and check up, that the wooden plate served as a stopper between the engine or an inlet collector and a partition of salon and an engine compartment.
|
|
- Remove bolts (4) cases of the lever of switching of gear wheels (3).
|
- Extend a hose сапуна.
|
|
In salon
Remove the case of the lever of switching of gear wheels, and then remove a bolt (1) back cases of transfer.
On the lift
|
|
|
|
- Remove transfer fixture (back fixture of the engine) (1), having removed bolts (2).
|
|
|
- Put a jack under a transmission (2) to prop up it.
|
- Remove фитинги wires of switches 4 WD (a full drive)/4WD - LOW (a full drive – bottom).
- Remove bolts of the forward case of transfer (1).
- Having propped up transfer (2) jack (1), shift it back and when it will separate from a transmission, lower it.
|
|
|
|