Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
- Transfer
The general description
+ Diagnostics
- Service out of a workshop
Oil of a distributing box
The gear change lever
The switch of transfer of the all-wheel drive car
+ Oil epiploons of transfer
The gauge of speed
Back fixture of the engine
The transfer module
Removal
Installation
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
The switch of transfer of the all-wheel drive car
Replacement
|
|
- Remove a console box and lift casings №2 and №3 levers of a transmission as it is described in the Head the Mechanical transmission (type 1), in Section the gear change Lever.
- Remove a casing №2 (4) levers of transfers, disconnect wires on the transfer case to release it, and extend фитинг (1).
- Replace the switch of a full drive (3) and connect, as was originally. The inhaling moment (a): 20 Н•м (2.0 kg th, 14.5 pounds-foots).
|
|
1 — фитинг
2 — a clip
3 — the switch of a full drive
4 — a casing №2 |
- Include the ignition switch, switch the gear change lever in position 4WD (a full drive) and check up, that the indicator burnt. After check switch off the switch.
|
|
- At removal and switch installation be accurate, that the dust has not got in a transmission.
- Do not forget to establish a clip on wires which are located so that them it is not visible.
- It is recommended to work with a casing №1 levers of a gear change from the bottom access when the car is lifted.
|
|
|
Check
|
|
- Disconnect a clip and фитинг the switch of a full drive.
- Work of the switch (2) switchings of a full drive can be checked up.
|
|
1 — an ohmmeter
2 — the switch |
- On these contacts there should be a conductivity when the switching lever is switched in position 4H and 4L.
- On termination of check connect фитинг and a clip of wires as was originally.
|
|
At switch replacement be accurate, that the dust has not got to transfer through a switch aperture. |
|
|
|
|