Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
- Transfer
The general description
+ Diagnostics
- Service out of a workshop
Oil of a distributing box
The gear change lever
The switch of transfer of the all-wheel drive car
+ Oil epiploons of transfer
The gauge of speed
Back fixture of the engine
The transfer module
Removal
Installation
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
The gear change lever
Removal
|
|
|
|
- Remove covers (1) from the central console boxes.
|
- Remove the top cover (2) back central console boxes.
- Remove 6 bolts, and then a back central console box.
- Uncover a casing.
|
|
- Lift a casing №3, a casing №2 (1).
|
- Remove a casing clip, and then lift a casing №1 (2) from the case of the lever of switching of a transmission (3).
- Fingers press downwards a cover of the case of a gear change (4), turn it counter-clockwise and pull out the lever of a gear change (5).
|
|
Check
|
|
- Check up the bottom part of the lever of a gear change and adjusting sheet of the lever on excessive deterioration.
- Check up a casing on damages.
- If necessary, replace or correct.
|
|
- If adjusting bolts (1) levers of switching are replaced or drawn, tighten them to the specified value of the moment of an inhaling.
|
- At replacement of adjusting bolts (1) levers of switching the clamp of a carving for carving blocking is required. “B”: a clamp of a carving 99000-32110. The inhaling moment (a): 17 Н•м (1.7 kg th, 12.5 pounds-foots).
- Put greasing on rotating parts and a nest, then establish the gear change lever. “A”: greasing 99000-25010.
|
|
- Establish the lever of a gear change (2) in the lever case.
|
- Having pressed a hand downwards a cover of the case of the lever of a gear change (1), turn it (1) clockwise.
|
|
- Establish a casing №1 (1) from within salon and reliably fix its new clip (2).
|
|
|
- Establish a casing №2 (2) with a cover of a casing (3) and an arm of a console box (1).
|
- Establish a console box.
|
|
Be convinced that the extending end of a casing №3 was combined with a console box. |
|
|
- Having combined a casing №3 (1) with covers (2), establish covers (2) on the central console boxes. (a): 17 Н•м (1.7 kg th, 12.5 pounds-foots).
|
|
|
|
|