Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
- Brake system
- Brakes
The general description
+ Diagnostics
The diagnostic table
- Check and adjustment
Стравливание air from brakes
Check of free height of the brake lever
Adjustment of the light switch of brakes
Check it is superfluous a pedal course
Check of a free wheeling of the brake lever
Check of level of a brake liquid
Check of a brake hose and highway
Check of the main cylinder
Check of a brake disk
Check brake Pads
Check of a brake boot
Check and adjustment of a lay brake
Washing of hydraulic system of brakes
Check of pressure of a liquid (if the car is equipped LSPV)
Check of work of the brake amplifier
Specifications - an inhaling twisting moment
Necessary materials for service
The special tool
+ Brake highway/hose the brake cylinder
+ Forward brakes
+ Lay and back brake
+ Antiblocking brake system (ABS)
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
Check and adjustment of a lay brake
Check
|
|
|
|
- Undertake the centre of the handle of a lay brake and pull it upwards with effort of 20 kg (40 pounds).
|
- When the lever of a lay brake will pull upwards count ratchet marks. Should be 5 - 7 marks.
- Also check up, whether the right and left back wheels are reliably blocked. That it was easier to consider marks, listen to ratchet clicks at a raising of the lever of a lay brake, without pressing the button.
- One click corresponds to one mark. If the quantity of marks does not correspond to the specification, adjust a cable having addressed to procedure of the adjustment described more low to receive a necessary course of a lay brake.
|
|
Check up, are not damaged and whether heads of a tooth of each mark are worn out. If damages or deterioration are found out, replace the lever of a lay brake. |
|
|
Adjustment
|
|
Before cable adjustment be convinced that following conditions are met:
- In brake system there is no air.
- Course of the brake lever such as it is required.
- The brake lever has been pressed some times with effort about 30 kg (66 pounds).
- The lever of a lay brake (1) has been some times lifted with effort about 20 kg (44 pounds).
|
|
|
- If the cable of a lay brake is replaced on new, lift the lever of a lay brake some times with effort about 50 kg.
- Back brake Pads are not worn out beyond the limit, and the self-regulation mechanism works properly.
- To weaken a cable of a lay brake (2), release самоконтрящуюся a nut (3) till the end of a bolt. Then press the brake lever a little with effort about 30 kg (66 pounds).
- Having convinced that all are met specified above a condition, adjust a course of the lever of a lay brake, having released or having tightened a lock nut.
|
|
Check up, whether заедает a brake drum after adjustment. |
Course of a lay brake (when the lever is lifted with effort 200 Н•м (20 kg, 44 pounds) - 5 - 7 marks. |
|
|
|