Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation



Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
- Suspension bracket
   - Forward suspension bracket
      The general description
      + Diagnostics
      - Service out of a workshop
         The stabilizer of cross-section stability/plug
         Shock-absorber rack
         Cylindrical spring
         The terminator of a dynamic course of a suspension bracket / a rubber nest of a spring
         Wheel nave (including the wheel bearing)
         Sharnir/os rotations
         The suspension bracket/plug lever
   + Back suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment




Shock-absorber rack

Removal

 PERFORMANCE ORDER

  1. Remove a bar of a rack (1) (if is available).
  1. Lift the car that the forward suspension bracket freely hung.
  2. Remove a wheel.
  1. Remove the E-shaped ring (1) protecting a brake hose, and remove a brake hose with скобы racks, as shown.
  1. If there is a system of antiblocking of brakes (ABS), remove a bolt (1) plugs of a wire of the gauge of speed of a forward wheel.
  1. Remove bolts скобы racks (1), then a jack (3) bottom lever (2).
  1. Remove nuts of a support of a rack (1). Hold a rack with a hand that it has not fallen.
  1. Remove a rack.
  1. Remove a nut of a rack (1), the top nest (2), a support (3), duster (4) and the bottom nest (5) from a rack of the shock-absorber (6).

Installation

 PERFORMANCE ORDER

  1. Establish a rack, carrying out in return sequence steps on its removal 1 – 9. Put bolts in the specified direction.
1 — a shock-absorber rack
2 — the bottom nest
3 — duster
4 — a rack support
5 — the top nest
6 — a rack nut
  1. Tighten all fixing elements to the specified values of the moment of an inhaling.
    • The inhaling moment:
      • Rack nut (a): 90 Н•м (9.0 kg th, 65.0 pounds-foots)
      • Nut of a support of a rack (b): 55 Н•м (5.5 kg - of m, 40.0 pounds-foots)
      • Bolt скобы (c): 95 Н•м (9.5 kg th, 69.0 pounds-foots)
      • Bolt (d): 50 Н•м (5.0 kg th, 36.5 pounds-foots)

  • Installation of a brake hose.
  • At installation of a hose do not overwind it. Establish the E-shaped ring (1), without falling outside the limits a surface скобы (2).