Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
- Start system
+ The general description
- Diagnostics
Block repair
Analysis
Assemblage
Survey
Work check
Specifications
Type 0.9 кВ
Necessary materials
The special tool
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
Analysis
|
|
- Before starter analysis, necessarily arrange a mark in those places (A and B) to avoid possible errors.
- Do not clamp a collar a vice and do not beat on it a hammer at repair.
|
|
|
1 — the electromagnetic switch
2 — a forward casing
3 — a collar |
|
|
- Remove a protector (if is) and the electromagnetic switch.
|
|
1 — the electromagnetic switch
2 — a protector |
|
|
Do not assort this switch. If it is faulty, replace it as assemblage. |
|
|
1 — the electromagnetic switch
2 — a spring
3 — the piston |
- Remove bolts, then disconnect assemblage of a reducer from starter assemblage.
|
|
1 — bolts
2 — reducer assemblage |
- To repair reducer assemblage, remove a lining and planetary transfers.
|
|
1 — planetary transfer
2 — a lining |
- Remove rubber consolidation and a plate.
|
|
1 — rubber consolidation
2 — a plate |
- Remove lever assemblage together with the lever.
|
|
1 — lever assemblage
2 — the lever |
- Release the lock ring of a gear fixed by a persistent ring.
|
|
1 — a persistent ring
2 — a lock ring of a gear
3 — assemblage обгонной муфты |
- Remove a persistent ring, then extend a lock ring of a gear, обгонную муфту and internal transfer. The special tool (A): 09900-06107.
|
|
1 — internal transfer
2 — a persistent ring
3 — a lock ring of a gear
4 — обгонная муфта |
- Remove back скобу and щеткодержатель.
|
|
1 — back скоба
2 — an anchor
3 — a collar |
- Remove an anchor from a collar and then a ball from the end of a shaft of an anchor.
|
|
1 — an anchor
2 — a collar
3 — a ball |
- Remove щеткодержатель with back скобы.
|
|
1 — back скоба
2 — щеткодержатель |
|
|
- Remove springs of brushes and a brush.
|
- Remove a cap back скобы, and then remove a back sleeve.
|
|
1 — back sleeves
2 — a cap back скобы
3 — back скоба |
|
|
|
|