Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation


Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
- Electric equipment
   - Body electric equipment
      + The basic description of the block of management of body electronics
      - Codes of diagnostics of malfunctions
         Check of a diagnostic code of malfunctions (КДН)
         Clearing of a diagnostic code of malfunction (КДН)
         The table of a diagnostic code of malfunction (КДН)
         The scanner information
         Terms and the formulations used in the scanner
         The table of signals on scanner SUZUKI exit in a test mode
      + The general description
   + Illumination system
   + Electric equipment system
   + Tools/information for drivers



Clearing of a diagnostic code of malfunction (КДН)

After repair or replacement of a faulty detail () (knot, the mechanism), erase all КДН, having executed following operations.

Using scanner "SUZUKI"

 PERFORMANCE ORDER

  1. Connect scanner "SUZUKI" to a data link socket in the same way, as well as at performance of check ДКН.
  2. Include ignition.
  3. Erase КДН according to instructions on the scanner display.
  4. For the additional information the Directory of the mechanic see.
  5. After КДН it will be erased, switch off ignition and disconnect the scanner from a data link socket.

Without scanner "SUZUKI" use

 PERFORMANCE ORDER

  1. Switch off ignition.
  2. Using a repair wire (2), connect feeding plug of a diagnostic socket to weight of the case (3).
  3. Include ignition, at the kept connection described in point 2.
2 — a repair wire
3 — the feeding plug
4 — an air inlet fragment
  1. Execute 5 cycles of connection/detachment of a repair wire from "weight" of the case within 10 seconds with an interval in 1 second (it is admissible большее quantity of cycles) (the wire is connected by other end to the feeding plug of a diagnostic socket).

About — it is opened
S — it is closed
Т — about 10 seconds

  1. After clearing end, switch off ignition and disconnect a repair wire from a socket of a control socket.