Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
- Electric equipment
- Body electric equipment
+ The basic description of the block of management of body electronics
- Codes of diagnostics of malfunctions
Check of a diagnostic code of malfunctions (КДН)
Clearing of a diagnostic code of malfunction (КДН)
The table of a diagnostic code of malfunction (КДН)
The scanner information
Terms and the formulations used in the scanner
The table of signals on scanner SUZUKI exit in a test mode
+ The general description
+ Illumination system
+ Electric equipment system
+ Tools/information for drivers
|
Codes of diagnostics of malfunctions
Check of a diagnostic code of malfunctions (КДН)
With scanner "SUZUKI" use
|
|
- To prepare scanner "SUZUKI".
|
|
- At the switched off ignition to attach the device to a socket of the data link (EFFICIENCY) (1), being under the instrument panel from outside armchairs of the driver. The additional device (): scanner "SUZUKI".
|
- Include ignition.
- Read the diagnostic code of malfunction represented on the display of scanner "SUZUKI" and unpack it or write down.
- For the additional information the Directory of the mechanic see.
- If information transfer process between the management block кузовной electronics and scanner "SUZUKI" is impossible, check up, whether this process with the management block on other car is carried out.
- If information transfer process in this case is carried out, scanner "SUZUKI" is in good repair. Then check up a socket of the data link and the consecutive chain which is in the car from which information transfer process it was not possible to carry out.
- After check end, switch off ignition and disconnect scanner "SUZUKI" from a data link socket.
|
|
Without scanner "SUZUKI" use
|
|
|
|
- Check up that with ignition inclusion display "Hours/rate" has joined also.
|
- Using a repair wire (2), earth contact of the diagnostic switchboard in a place of control connection (3).
- At the included ignition and the idle engine, read КДН, represented on display "Hours/rate". Find conformity in the Table of a diagnostic code of malfunction (КДН).
- After check will be finished, switch off ignition and disconnect a repair wire from a place of control connection.
|
|
2 — a repair wire
3 — control connection
4 — "weight" of the case
5 — an air inlet fragment |
|
|
|
|