Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
- Coupling
The general description
Diagnostics
- Service out of a workshop
Liquid check
Height of a pedal of coupling
Free wheeling of a pedal of coupling
Tube and hose of a liquid for coupling
The main cylinder of coupling
The cylinder of work of coupling
+ Module repair
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
Tube and hose of a liquid for coupling
Removal
|
|
Avoid liquid hit on the painted surface. |
|
|
|
|
- Remove a dust and a dirt from everyone шлангового connections (2) and tubes (1) which will be separated, and clear round a tank cover.
|
- Type a liquid a syringe or something similar.
- Disconnect a tube for a liquid from a hose.
|
|
To disconnect a tube (1) from a hose (2), separate them by means of a key for развальцованных nuts (4) and a wrench (3) so that not to overwind them. |
|
|
Check
|
|
Check up a tube (1) and a hose (2) on dents, excesses, cracks, a dirt and a dust. If results of check are unsatisfactory, replace. |
Installation
Execute removal procedure in return sequence, paying attention to the following:
|
|
Tighten развальцованные nuts (3) to the specified value of the moment of an inhaling. The inhaling moment (a): 16 Н•м (1.6 kg th, 11.5 pounds-foots). |
|
|
|
|
- For стравливания air only from the main cylinder, it is necessary for removing from the car.
- Procedure of removal and installation of the main cylinder and стравливания air is described in Section the Main cylinder of coupling.
- Avoid liquid hit on the painted surfaces.
- Watch, that a tube (1) and a hose (2) did not concern the car or other parts.
- Reliably establish all clips.
- Reliably establish the E-shaped ring (3).
- After installation check up a free wheeling of a pedal of coupling and pit air from system.
- Check up, whether there is no liquid leak.
- Add a liquid approximately to mark MAX (maximum) on the tank.
|
|
|
|