Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
- Engines
+ Mechanical part of engine G16
+ Mechanical part of engine J20
- Engine cooling
+ The general description
+ Diagnostics
- Maintenance service
Check of level of a cooling liquid
Service and repair of system of cooling
Washing and filling of system of cooling
Regulation and check of a tension of a belt of the cooling fan
+ Vehicle routine maintenance
Necessary service materials
Technical characteristics of the rotating moment of an inhaling
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
Washing and filling of system of cooling
|
|
- Uncover a radiator when the engine will cool down. Slowly turn a cover on the left until it will not reach a point of "feet" (do not press when turn). Wait while pressure will be dumped (a hissing sound specifies in it), then press a cover and continue to turn on the left.
|
|
In order to avoid a burn do not uncover a radiator, while the engine and a radiator still hot. A burning liquid and steam can be splashed out under pressure if the cover is removed too early. |
- Having uncovered a radiator, start the engine, the top hose of a radiator (it shows that the thermostat is opened and the cooling liquid moves on system) will not heat up yet.
- Switch off the engine and open a drain stopper of a radiator to merge cooling liquid.
|
|
- Close a drain stopper (1). Add waters while the system will not be filled, and start the engine while the top hose of a radiator again will not heat up.
|
- Repeat points 3) and 4) some times until the merged liquid does not become almost colourless.
- Merge cooling system, and then strong close a drain stopper of a radiator.
- Disconnect a hose from the tank (1). Remove the tank and merge a liquid. Потрите also clean the tank inside with soap and water. Well wash out its pure water and drain. Establish the tank and a hose into place.
- Add a mix 50/50 этилен гликолевого antifreeze of high quality and water in a radiator and the tank. Fill a radiator to a bulk mouth and the tank to a mark of level "FULL" (2). Establish a tank cover, having levelled arrows (4) on the tank and a cover.
|
|
1 — a hose from the tank
2 — a mark of high level
3 — a mark of low level |
- Start the engine with an open cover of a radiator until the top hose of a radiator will not heat up.
- At the engine idling, fill in cooling liquid in a radiator to level of a jellied mouth. Establish a radiator cover, having convinced that cover clips are levelled with a tank hose.
|
|
|
|